Cocraft HT 10 Original Bedienungsanleitung Seite 10

Setting the saw blade height
Turn the hand wheel (15) to set the desired height. Never set the blade
higher than is necessary to saw through the workpiece.
Rip cutting
Note Important
• Rehearse every step of the cutting task without turning the saw on if you are unsure how to hold the workpiece
and work safely.
• Make a test cut on a scrap piece of wood to check the setup before starting to rip cut the actual workpiece.
• Always let the saw come up to full speed before starting to cut.
• Be extra careful at the beginning of every cut.
• Hold one side of the material against the rip fence and the flat face against the surface of the table.
• Do not stand directly behind the workpiece when rip cutting. The workpiece can be thrown back towards the operator.
• Place your hands on the workpiece and press it against the table and the rip fence. Feed the workpiece into the blade in
a controlled and smooth motion.
Warning:
Always use a push-stick if any of your hands comes closer than 125 mm to the saw blade during the cutting process.
Never use a damaged push-stick, replace a damaged stick before resuming work. Leave the offcuts on the saw table until
the saw blade has completely stopped rotating after the saw has been switched off.
Setting the blade tilt
Important
Check all the angles before starting to saw. Make a test cut on a scrap piece of wood to check the setup before starting to
cut the actual workpiece.
1. Undo the locking knob (14).
2. Push in the blade height/tilt angle hand wheel (15) and
set the desired angle.
3. Tighten the locking knob again.
10