Panasonic HBE5 Serie Bedienungsanleitung Seite 5

FAN
SPEED
TO SELECT FAN SPEED (3 OPTIONS)
AUTO
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• If the operation mode is set to Fan, the fan speed will
be fi xed at MED regardless of the temperature setting.
ECONOMY
TO REDUCE POWER CONSUMPTION
• Recommend to use when desired room temperature is
reached.
• Economy operation can be activated in all modes and
can be cancelled by pressing the respective button
again.
ODOUR WASH
ODOUR REMOVING
• Applicable for all models.
• Helps to remove unpleasant odour from the
surrounding area during operation.
• To enable the odour removing function, press the
once.
ODOUR WASH
• To cancel, press the respective button again.
ODOUR CLEAR
• Applicable for Inverter model only.
• To remove odour and minimize the growth of odour
causing moulds in the air conditioner's interior section.
• To enable this function, press the
3 seconds.
• The unit will automatically perform Fan and Heating
modes for approximately 20 minutes and then stops
automatically.
• Recommended to open the windows during this
operation.
LO MED HI
for more than
ODOUR WASH
TO SET DAILY TIMER TO SET DAILY TIMER
• To turn ON or OFF the unit at a preset time.
1
MODE
Enter daily timer mode.
3
UP
DOWN
Set the time.
• To cancel ON or OFF timer, press
• When ON timer is set, the unit may start early before
the actual set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control preparation.
• The timer closest to the current time will be activated
fi rst.
• If timer is cancelled manually, you can restore the
previous setting by pressing
• If the main power is switched off for an hour or more,
the clock and timer will need to be set again.
HINTS HINTS
• Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
• Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
2
SELECT
Select ON or OFF timer.
4
SET
Confi rm.
CANCEL
.
SET
.
5