CME EASYTEL one 100 Gebrauchsanleitung Seite 9

PROGRAMMED CODE NOTING
Always write down the 4-digit code for your remote
control on the label inside the battery cover after
running the search and saving the code.
This may be useful if you need to reprogram your
remote control in the event of accidental cancellation or
when you change used batteries.
To find the code for your remote control:
1. Hold down the
indicator at the top starts to flash.
2. Release the
key.
3. After a few seconds, the light indicator communicates
the code you are looking for by flashing the four
numbers separately. Count the number of flashes for
each code number. For example, for the code 1306, the
key flashes three, zero and six times to give:
4. Note this code on the label inside the battery cover, for
rapid consultation.
RE-PROGRAMMING YOUR REMOTE CONTROL
BY ENTERING THE CODE NOTED DOWN
1. Hold down the
the light indicator at the top starts to flash indicating
that the remote control is programming.
2. Release the
you noted down previously. Three flashes indicate that
the code has been saved correctly. If not, try the code
entry procedure again from point 1.
and number keys until the light
and keys and then press the
= 1
= 3
= 0
= 6
and number keys together until
and keys. Then enter the code
1
-/--
9