CME EASYTEL one 100 Gebrauchsanleitung Seite 8

GLOBAL SEARCH REMOTE CONTROL
B
1.
Make sure that the TV is
ON.
2.
Hold down the
number keys together
until the light indicator at
the top starts to flash
indicating that the remote
control is programming.
3.
Release the keys. Within
15 seconds, enter the
code 0000.
The light indicator flashes
more quickly to indicate
that the remote control is
ready for the search.
4. Point the remote control
at the TV. Press and
release the
several times. Stop when
your TV goes OFF (you
may have to press the
key over a hundred times).
Identify and take note of the code which you have searched
for following the code noting procedure
(see "PROGRAMMED CODE NOTING" section).
NOTE: during the search operation, the light indicator flashes
more quickly. The light indicator stops flashing and the
remote control leaves the programming mode in the following
cases:
• if no keys are pressed for 12 seconds.
• if the code search list is completed. In this case, visit
www.cme.it
8
PROGRAMMING
This operation may take up to an hour.
and
key slowly
5. When your TV is off, press
the key to confirm.
AV
Three long flashes
indicate that the operation
has been completed
correctly.
Additional check
Check that some of the
other functions used on your
original remote control are
working correctly.
If the commands function
incorrectly or erratically, you
have probably entered a
code for a similar but
different remote control.
In this case, repeat the
search procedure from
point 2.