Noise Gate; Adding Effects - Kemper PROFILER Schnellstart

PROFILER QUICKSTART 11

NOISE GATE

STOM
Adjust the input Noise Gate intensity with the NOISE GATE knob in
the upper left corner.
MOD
Set the volume of your guitar all the way up and put your palm
on the strings so that they are muted. Next, increase the Noise
Intensity
~ 4-6
Gate intensity until the hum and noise produced by your guitar
disappears (usually happens in the range of 4 - 6).
SYSTEM RIG QUICK
TYPE
For metal sounds, we recommend adding one of the special noise
gate stomps, which are explained in the Main Manual. There is also
a tutorial video dedicated to the noise gates available on:
www.kemper-amps.com/video

ADDING EFFECTS

The PROFILER features eight effects modules. Four are located
MOD DELAY
X REVERB
before the amplifier module (pre), and four are located after it OUTPUT
EFFECTS
(post). Modules A, B, C and D are pre amplifier and X, MOD, DLY
and REV are post amplifier.
MOD DELAY REVERB