Fluke Networks SimpliFiber Pro Bedienungsanleitung Seite 9

Spectral width (RMS)
Minimum output
power
Power output
1
stability
Auto dual-wavelength
switching
Optical connector
FindFiber ID
generation
Output modes
Power requirement
2
Battery life
Automatic power-off
Low battery warning
Size
Weight
1. 23°C ±2°C, after 5 minutes of warm-up time.
2. In auto-wavelength mode. Battery life depends on the condition
and type of batteries used. Fluke Networks recommends alkaline
batteries.
1310 nm: 2 nm (maximum)
1550 nm: 3 nm (maximum)
1490 nm/1625 nm: 1 nm
(maximum)
1310 nm/1550 nm: -7 dBm
(typical)
1490 nm/1625 nm: -3 dBm
(typical)
±0.25 dB over 8 hours
Yes. Can be enabled or disabled
by the user.
Fixed SC
Yes. 1310 nm/1550 nm is fixed at
ID 2. 1490 nm/1625 nm is fixed at ID
3.
CW (continuous wave), 2 kHz
modulated, auto-wavelength
2 AA alkaline batteries, NEDA
15A, IEC LR6
30 hours (typical)
30 minutes (can be disabled by the
user)
Blinking LED
5.6 in x 3.2 in x 1.6 in
(14.2 cm x 8.1 cm x 4.1 cm)
9.8 oz (278 g)
Specifications
7