Fluke Networks SimpliFiber Pro Bedienungsanleitung Seite 5


Do not put battery cells and battery packs near
heat or fire. Do not put in sunlight.

Have an approved technician repair the
Product.

To avoid possible eye damage caused by hazardous
radiation:

Never look directly into optical connectors.
Some sources produce invisible radiation that
can permanently damage your eyes.

Never turn on the source unless a fiber is
attached to the port.

Do not use magnification to view the optical
outputs without proper filtering.

Use of controls, adjustments, or procedures not
stated herein might result in hazardous
radiation exposure.
To avoid damaging fiber connectors, to avoid data
loss, and to ensure maximum accuracy of test
results:

Use proper cleaning procedures to clean all
fiber connectors before every use. Neglecting
this step or using improper procedures can
cause unreliable test results and may
permanently damage the connectors.

Cover all connectors with protective caps when
not in use.

Never connect the source to an active network.
Doing so can disrupt network operations.

After you turn on the source, let it warm up for
10 minutes before use. Allow additional time if
the source has been stored above or below
ambient temperature.
Warning: Class 1 Laser

Caution
Safety Information

3