Inhaltsverzeichnis
Werbung
Storage and transport
humidity
This symbol indicates the
acceptable humidity range for
storage and transport
environments.
Storage and transport
pressure
This symbol indicates the
acceptable atmospheric
pressure range for storage and
transport environments.
For customers in the U.S.A.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
All interface cables used to connect
peripherals must be shielded in order to
comply with the limits for a digital device
pursuant to Subpart B of part 15 of FCC
Rules.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
For customers in Canada
This unit has been certified according to
Standard CAN/CSA-C22.2 No.60601-1.
AC-81MD only
For customers in the U.S.A. and
Canada
Model AC-81MD is non-patient equipment.
The unit cannot be used in the vicinity of
patients.
Patient vicinity
Important safeguards and notices
for use in the medical
environments
1. All devices connected to the unit must be
certified or compliant according to
IEC 60601-1, IEC 60950-1, and
IEC 60065 standards and other IEC/ISO
standards applicable to the devices.
2. Furthermore, the system as a whole must
comply with IEC 60601-1 standards. All
peripheral devices connected to the
signal input/output sections of the unit
GB
3
GB
Werbung
Inhaltsverzeichnis
