Troubleshooting - Pulsar DIGEX serie Handbuch

Precautions
• Do not allow water to enter the illuminator body. This can disable it.
• Independent alterations or repairs of the illuminator are prohibited.
Contact the manufacturer for qualified support if any issues arise.
• When using the battery at sub-zero temperature, the battery capacity
decreases, this is normal and not a defect.
• Do not charge the battery immediately after bringing it from cold to warm
place. Wait for 30-40 minutes so that the battery may warm up.
• To charge the battery, always use the unit supplied with your device (may
not be included in the package contents). The use of any other charger
may irreparably damage the battery pack or the charger and may cause
fire.
• Do not leave the battery unattended while it is being charged.
• After being stored for a long time, the battery should be partially charged:
it should not be completely charged or completely discharged.
• Do not submerge the battery.
• Do not dismantle or deform the battery. Do not drop or strike the battery.

Troubleshooting

Malfunction Possible cause
Uneven light Dirty lens.
emission of IR
spot.
Illuminator does Discharged battery.
not turn on by
Dirty contacts.
pressing the
power button.
Low light Dirty lens.
emission of IR
spot.
The IR illuminator knob
(8) is in the position of a
minimum transmission
power.
The term of a possible repair of the product is 5 years.
Solving
Clean the lens as described
in the Maintenance section.
Insert a charged battery.
Check for debris and dirt on
the terminals in the battery
compartment.
Clean the lens as described
in the Maintenance section.
Set the optimum power by
turning the IR illuminator
knob (8).
ENGLISH
4