Pulsar DIGEX serie Handbuch Seite 5

Installing the battery pack in the IR illuminator
LED indicator
Lever of
eccentric
The IR illuminator for the Digex riflescope is powered by APS2 battery pack.
• To install the battery in the IR illuminator, turn the battery cover (1)
counterclockwise and remove it.
• Install the battery into the battery compartment (2) along the special
guides in the IR illuminator body designed for it.
• When properly installed, the battery is fixed in the battery compartment (2).
• Close the battery compartment cover, turning it clockwise.
The illuminator is equipped with LED indicator (3) making possible the
current battery level monitoring. Indication modes are in the table below:
IR Operating Mode
The illuminator is on, power supply 3.2 - 4.2 V Green LED (3) is on
The illuminator is on, power supply <3.2 V,
an approximate operating time before the IR
illuminator turns off is 30 minutes
The illuminator is off
Installing the IR illuminator on the riflescope
• Open the mount ring (4) of the IR illuminator.
• Put the mount on the riflescope body so that the mount half rings encircle
the riflescope body.
• Raising the eccentric lever (5), move it to the left. Align the eccentric axis
with the groove of the moving half ring. The eccentric lever (5) shall take
its seat.
3
5
Eccentric pin 6
Fig.
1
7 Power button
2
Battery
1
compartment
Battery
compartment
4
cover
Ring mount
Indicator color
Red LED (3) is on
LED (3) is off
2
ENGLISH