IC iCMPDA1 Installationsanleitung Seite 15

Installation Instructions
3C
L x2
2 3
4
1
5 L x2
100 x 100mm Flush Mounting Hole Pattern
IMPORTANT!
This procedure only applicable when 100x100mm
mounting holes on back of display are flush with back surface of
display, OR brackets (C, E) were previously installed per Steps 3A
or 3B.
WARNING:
EXCEEDING THE WEIGHT CAPACITY CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! It is the installer's responsibility to make sure the
combined weight of all components attached to the iCMPDA1
does not exceed 75 lbs (34 kg).
1. Ensure Centris bracket can swivel and tilt easily, yet still be tight
enough to hold display in desired position. Adjust as required
before proceeding. See "ADJUSTMENT".
CAUTION:
USING SCREWS OF IMPROPER SIZE CAN
DAMAGE DISPLAY! Screws should easily and completely
thread into display mounting holes.
2. Using a Phillips screwdriver, install two screws (L) into upper
threaded mounting holes in back of display (or in brackets
C, E; if installed).
3. Thread screws completely into display (or in brackets C, E; if
installed), then back out 3 complete turns.
WARNING:
INADEQUATE THREAD ENGAGEMENT
IN DISPLAY CAN LEAD TO MOUNT FALLING CAUSING
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Back out screws ONLY as necessary to
allow installation of Centris bracket!
4. Lift and align display so that screws in back of display (or in
brackets C, E; if installed) fit into upper teardrop mounting
holes in Centris bracket. Lower display into place.
NOTE:
DO NOT tighten screws at this time.
5. Using Phillips screwdriver, install two screws (L) through lower
teardrop mounting holes in Centris bracket into display (or in
brackets C, E; if installed).
6. Tighten all four screws (L). Do not overtighten!
iCMPDA1
15