Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
30
Technical data
Problem
The lamp does not work.
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.
Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Pull outwards the hook of the lamp cov-
er.
3. Remove the lamp cover.
4. Replace the lamp with one of the same
power (the maximum power is shown on
the light bulb cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
8. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Technical data
Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
Height
Width
Depth
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
2
3
1850 mm
595 mm
632 mm
18 h
Solution
1
Werbung
Kapitel
Inhaltsverzeichnis
