CHIEF iC Serie Installationsanleitung Seite 12

iCSPDA2
2
2
3
12
INSTALL ARM ASSEMBLY TO WALL PLATE
IMPORTANT!
proceed to "INSTALL DISPLAY TO ARM ASSEMBLY" before installing arm
A
assembly to wall plate.
1. Align arm assembly (A) with wall plate (B) and slide into position.
WARNING:
may allow arm assembly (A) to fall, resulting in serious personal injury or
damage to equipment! Hex head screw should fully recede into arm
assembly hole after tightening.
1
2. Using hex key (T), tighten hex head screw in arm assembly (A) ensuring
that screw engages one of three holes in wall plate (B).
NOTE:
Three holes are provided in wall plate (B) to provide height
adjustment.
B
3. Align cover (C) with grooves in wall plate (B) and slide into position.
4. Align caps (D) with holes in wall plate (B) and slide into position.
2
If installing a display with recessed mounting holes, then
Failure to align hex head screw with hole in wall plate (B)
3 C
B
Installation Instructions
4 D x2
B