Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG Electrolux SANTO 75328-2 DT Benutzerhandbuch

Problem
There is too much frost.

Replacing the lamp

CAUTION!
Disconnect the plug from the mains socket.
1. Press on the rear hook of the lamp cover by a
screwdriver and at the same time pull and ro-
tate the cover in the direction of the arrow.
2. Replace the lamp with one of the same power
(the maximum power is shown on the light
bulb cover).
3. Install the lamp cover by fixing it into its orig-
inal position.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

Installation

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Possible cause
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Height
Width
Depth
Technical data
Solution
Wrap the food correctly.
Set a higher temperature.
1
2
1750 mm
600 mm
645 mm
20 h
31