Interconnections; Input Power Connector (Line Type); P3 - Vent; P5 - External Fan - Varian Mini-TASL 969-9170 Bedienungshandbuch

INTERCONNECTIONS

Input power connector (Line type)

The following figure show the input power connec-
tor.

P3 - Vent

This is a dedicated 24 Vdc connector to control the
optional vent valve.
P5 – External fan
This is a dedicated 24 Vdc connector to supply an
external fan.

J5 - IN-OUT

This connector carries all the input and output sig-
nals to remote control the Mini-TASK.
It is a 15-pins D type connector; the available sig-
nals are detailed in the table, the following para-
graphs describe the signal characteristics and use.
PIN N.
1 START/STOP (+)
2 START/STOP (-)
3 INTERLOCK (+)
4 INTERLOCK (-)
5 SPEED SETTING (+)
6 SPEED SETTING (-)
7 SOFT START (+)
8 SOFT START (-)
9 +24 Vdc
10 SPARE
11 PROGRAMMABLE SET POINT
12 SPARE
13 FAULT OUTPUT
14 PROGRAMMABLE ANALOG
SIGNAL (+)
15 •
GROUND (24 Vdc)
•
PROGRAMMABLE ANALOG
SIGNAL (-)

Signal description

START/STOP: input signal to start or stop the
pump. Without the supplied cover connector, if you
want to stop the turbo-pump from outside, you
have to connect the START/STOP (+) signal to the
+24 Vdc pin and the START/STOP (-) signal to the
GROUND pin (this is the default configuration of
the cover connector).
INTERLOCK: input signal to control the pump ro-
tation. With the supplied cover connector the IN-
TERLOCK (+) signal is connected to the +24 Vdc
pin and the INTERLOCK (-)signal to the GROUND
pin: in this condition the pump is stopped.
58
TECHNICAL INFORMATION
SIGNAL NAME
OUTPUT
87-900-962-01(A)
INPUT/
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
OUT
OUT
OUT