Control Panel - Zanussi ZQF11430DA Benutzerhandbuch

Control panel

Pilot light
1
Temperature regulator
2
Fast Freeze light
3
Fast Freeze switch
4
Acoustic alarm reset switch
Alarm light
5
Switching on
1. Insert the plug into the wall socket.
2. Turn the Temperature regulator clockwise to a medi-
um setting.
3. The Pilot light will light up and a sound is on only
for 2 sec. indicating that the appliance is powered.
4. The Alarm light will blink and the sound signal alarm
will get on, indicating that the temperature inside the
appliance is too high.
5. Push the Fast Freeze switch and the sound signal
alarm will get off.
6. Push the Fast Freeze switch once again and the Fast
Freeze light will light up. The freezer will start to op-
erate.
Switching off
1. To turn off the appliance, turn the Temperature regu-
lator to the "O" position and a sound is on only for 2
sec.
2. The pilot light will switch off.
Temperature regulation
The temperature within the appliance is controlled by the
Temperature regulator situated at the bottom of the cabi-
net.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to
obtain the minimum coldness.
1 2 3 4 5
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast Freeze function
You can activate the Fast Freeze function by pressing the
Fast Freeze switch.
The Fast Freeze light will light up.
It is possible to deactivate the function at any time by
pressing Fast Freeze switch.
The Fast Freeze light will switch off.
Excessive temperature alarm
If the temperature inside the freezer has risen to a point
where the safe storage of frozen food is no longer ensured
(for example due to an power failure) the Alarm light will
blink and an acoustic alarm will sound.
1. Switch off the warning tone by pressing the Fast
Freeze switch.
The Fast Freeze light illuminates.
The Alarm light blinks until the required temperature
has been reached again.
2. The Fast Freeze switch can be released as soon as
the Alarm light is off.
The Fast Freeze light goes out.
When the freezer is first switched on, the Alarm light
blinks until the temperature has dropped to a safe
level for the storage of frozen food.
13