Operation; Control Panel - Zanussi ZFC623WAP Benutzerinformation

Environment Protection
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant cir-
cuit or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish. The

Operation

Switching on
Insert the plug into the wall
socket.
The Pilot light will light up.
Turn the Temperature regu-
lator clockwise.
Important! If the temperature
inside the appliance is too
high the Alarm light will
light up.
Switching off
To turn off the appliance, turn the Temperature regulator
to the OFF position.

Control panel

5
1 Pilot light
2 High temperature alarm light
3 Fast Freezing light
4 Fast Freezing switch
22
1 2 3
4
insulation foam contains flammable gases: the appliance
shall be disposed according to the applicable regulations
to obtain from your local authorities. Avoid damaging the
cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the
symbol are recyclable.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator towards
the minimum coldness.
• turn the Temperature regulator towards
the maximum coldness.
A medium setting is generally the most suitable.
5 Temperature regulator
Fast Freezing function
You can activate the Fast Freezing function by pressing
the Fast Freezing switch.
The Fast Freezing light will light up.
It is possible to deactivate the function at any time by
pressing the Fast Freezing switch. The Fast Freezing light
will switch off.
High temperature alarm
An increase in the temperature in the freezer (for example
due to an power failure) is indicated by switching on of
the Alarm light
During the alarm phase, don't place food inside the freez-
er.
When normal conditions are restored the Alarm light will
switch off automatically.
to obtain
to obtain