Operation; Control Panel; Temperature Regulation - Zanussi ZFT11407WA Benutzerinformation

OPERATION

CONTROL PANEL

1
Green Indicator Light
1
Red Indicator Light
2
Temperature Regulator
3
SWITCHING ON
Leave the appliance to stand upright for 4 hours
after installation.
Insert the plug into the wall socket.
1. Turn the Temperature Regulator clockwise to
the Full Loaded position.
The Green Indicator Light will light up and remain lit
until the appliance is switched off.
2. Leave to run for 8 hours to allow the correct
temperature to be reached before placing food
inside.
The Red Indicator Light will stay on until the
correct temperature is reached.
3. When the appliance has reached the set
temperature (the Red Indicator Light has gone
out) adjust the Temperature Regulator
according to the quantity of the stored foods.
A few hours after starting up the Red
Indicator Light will go out to show that
the correct temperature has been
reached for the setting chosen and will
stay out to indicate that everything is in
order. It will come on if the freezer
temperature rises unduly for instance,
after opening the freezer door or
placing food inside the cabinet, but
the light should go out again when the
temperature returns to the correct
storage level.
2
Half Loaded position
4
Full Loaded position
5
SWITCHING OFF
To turn off the appliance, disconnect the mains
plug from the wall socket.

TEMPERATURE REGULATION

The temperature within the appliance is controlled
by the Temperature Regulator situated on the
control panel.
To operate the appliance, proceed as follows:
• turn the Temperature Regulator toward MIN to
obtain the minimum coldness.
• turn the Temperature Regulator toward MAX to
obtain the maximum coldness.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature,
• how often the door is opened,
• the quantity of food stored,
• the location of the appliance.
5
In case of freezing less food volumes,
the Half Loaded setting is the most
suitable. In case of freezing large food
volumes, the Full Loaded setting is the
most suitable.
CAUTION! Do not place heavy nor
hot objects on top of the appliance to
avoid any damage.
3
4
47