Displaying The Camera Information - Panasonic AW-HS50E Bedienungsanleitung

7. Function for linking up with the remote camera controller

7-2-3. Displaying the camera information

The following setting information of the remote cameras
captured by the AW-RP50 can be displayed on the unit's
AUX bus output image or multi view display image.
 Video format
 Scene file name (shooting mode)
 Filter information
 Remote camera alarm information
 Shutter information (ON/OFF, shutter value)
 Gain value
 Iris value
 Remote camera name (displayed with up to
10 characters)
1080/59i U SER
1/100 A UTO
AW- HE5 0
[Settings established at the AW-RP50]
 Set the remote cameras that correspond to the unit's
image input.
(On the AW-RP50, SDI IN 1 to 4 are displayed as
INPUT1 to 4 while DVI-IN is displayed as INPUT5.)
 Enable the camera information display function
(CAMINF).
 Set whether to display each of the items ( to 
listed above).
Notes
  The information is not displayed for outputs from the
SDI OUT 1 connector.
  The information is not displayed in Pos3 to Pos6 for
screens split into a 6-part layout or in Pos3 to Pos10
for screens split into a 10-part layout.
  Information of the cameras connected in the network
to the AW-RP50:
  Information of the cameras connected serially to the
AW-RP50:
,
C LO SE
54 (E)
Only the information of the cameras included in the
group now selected by the AW-RP50 is displayed.
Only the information of the cameras selected by the
AW-RP50 is displayed.