Setting The Ancillary Data - Panasonic AW-HS50E Bedienungsanleitung

4. System settings

4-1-2. Setting the ancillary data

A function for allowing the V ancillary data and embedded
audio data of the SDI input signals to pass through can be
set.
When an HD format is used:
The ancillary data starting with line 9 is allowed to
pass through.
When an SD format is used:
The ancillary data starting with line 12 is allowed to
pass through.
 When 1080/59.94i, 720/59.94p or 1080/50i has been
selected as the unit's video format setting, it is not
possible to allow the ancillary data and embedded
audio data to pass through even if SD format signals
(480/59.94i or 576/50i) have been input in the Dot by
Dot mode or up-converter (UC) mode.
 Refer to "2-1-1. Setting the input mode".
[14] SYSTEM Menu
4. AUX Anci
On or Off is selected here as the setting for the AUX output
signals.
On: The ancillary data and embedded audio data of the
SDI input materials selected by the AUX bus are
allowed to pass through.
Off: The ancillary data and embedded audio data are not
allowed to pass through.
 The data is not allowed to pass through when KEY
OUT or CLN material has been selected.
[14] SYSTEM Menu
5. PGM Anci
On or Off is selected here as the setting for the programme
output signals.
On: The ancillary data and embedded audio data of the
SDI input materials selected by the PGM bus are
allowed to pass through.
Off: The ancillary data and embedded audio data are not
allowed to pass through.
[14] SYSTEM Menu
6. PVW Anci
On or Off is selected here as the setting for the PVW output
signals.
On: The ancillary data and embedded audio data of the
SDI input materials selected by the PST bus are
allowed to pass through.
Off: The ancillary data and embedded audio data are not
allowed to pass through.
[14] SYSTEM Menu
7. MV Anci
PGM, PVW or Off is selected here as the setting for the
output signals of the multi view display.
PGM: The ancillary data and embedded audio data of the
SDI input materials selected by the PGM bus are
allowed to pass through.
PVW: The ancillary data and embedded audio data of the
SDI input materials selected by the PST bus are
allowed to pass through.
Off: The ancillary data and embedded audio data are not
allowed to pass through.
Note
The sounds generated when the video signals are
switched will be added to the embedded audio data
which is output from the unit.
40 (E)