External Device Control Interfaces; Lan Connection; Tally/Gpi - Panasonic AW-HS50E Bedienungsanleitung

5. External device control interfaces

5-1. LAN connection

Use LAN cables to connect the AW-HE50, AW-RP50 and host computer.
When connecting the unit directly to another device, use a crossover cable.
For network connections via a device such as a hub (switching hub), use straight cables.
When a hub is not going to be used, ensure that the length of the LAN cable does not exceed 100 meters (when a cable of
category 5 or above is used).
  For further details on the AW-HE50 and AW-RP50 connections and settings, refer to "2-2-2. Example of connections"
(<Basics> Operating Instructions).
  For details on the functions available when connection has been made to the host computer, refer to "6. Connections with a
computer".

5-2. TALLY/GPI

The TALLY/GPI connector features five contact input ports
for controlling the unit from an external device and seven
open collector output ports for outputting the tally and status
information from the unit to an external device.
Pin
Signal
No.
1 TALLY OUT1 Open collector output
2 TALLY OUT2 Open collector output
3 TALLY OUT3 Open collector output
4 TALLY OUT4 Open collector output
5 TALLY OUT5 Open collector output
6 ALARM Open collector output
7 KEY ON Open collector output
8 (RESERVE) Contact input
9 NC
10 Tally Disable Contact input
11 AUTO Contact input
12 CUT Contact input
13 KeyON Contact input
14 PinPON Contact input
15 GND Ground
Example of an open collector output connection
Ensure that the conditions given below are satisfied.
Dielectric strength: Max. DC 24 V
Current: Max. 50 mA
AW-HS50
TALLY OUT1 – 5
ALARM
KEY ON
(Max. current: 50 mA)
GND
Input/output
Tally output of input image 1
Tally output of input image 2
Tally output of input image 3
Tally output of input image 4
Tally output of input image 5
Fan alarm or power alarm output
Key combination status output
(Reserve)
Not used
Tally signal enable/disable
AUTO button of transition part
CUT button of transition part
KEY ON button of transition part
PinP button of transition part
Ground
(Max. voltage: 24 V)
Tally LED
(D-sub 15-pin, female, inch thread)
Details of signal
Example of a contact input connection
Provide contact inputs.
AW-HS50
+3.3 V Tally Disable
AUTO
CUT
KeyON
PinPON
GND
45 (E)
8 1
15 9
Operation
A low-level signal is output during tally
output.
A low-level signal is output when trouble
has occurred.
A low level is output during key
combinations.
This signal is enabled by the contact
input (and disabled when open).
The signal is made operational by the
contact input (30 ms or more).