Chlorine Production Regulation - Swim & Fun Easy Salt 30 m2 Bedienungsanleitung

5.4

Chlorine production regulation

The chlorine production of the device settles from OFF TO 100 %, using the navigations keys UP
and DOWN.
Chlorine production:
PRODUCTION %
0
10
20
30
40
50
60
70
80
90
100
Check the rate of free chlorine production of the pool every week with your usual analysis kit. The
free chlorine must be between 0,7 and 1,4 ppm. If not, put the device on the position 10 (100 %)
and let it run until you get a sufficient concentration (from a few hours to a few days).
Important
For the protection and longevity of your pool equipments, it is imperative to respect the
instructions of use mentioned in this manual. The presence of any automatic regulation
devices will not remove the chance that other factors may cause damage, in particular:
• An insufficient ventilation (shelter, tarpaulin, cover)
• A maintenance default of analysis probes
• Manual processing of excessive or not adapted supplements
• Non-compliance with the instructions of use described in the present user manual
These factors can cause oxidation on all metallic parts and of automatic cover pins and
slats, telescopic shelters and heat exchangers and can lead to irreversible deterioration
(discoloration) of the pool lining.
If the manufacturer's responsibility was engaged for a malfunction of the control or re-
gulation device, it would be limited to the repair or the replacement of the product free
of charge. Therefore, it is strongly recommended to check the levels of chlorine and pH
each week with your usual analysis kit.
50
LED
"OFF" led solid green
"20" led flashes
"20" led solid green
"40" led flashes
"40" led solid green
"60" led flashes
"60" led solid green
"80" led flashes
"80" led solid green
"100" led flashes
"100" led solid green
MV-1810-03-2018 . © All rights reserved Swim & Fun Scandinavia ApS
UK