Parameters Setting; Control Panel; On/Off Function; Self-Cleaning Of The Cell - Swim & Fun Easy Salt 30 m2 Bedienungsanleitung

UK
Salt adding:
Actual salt rate (Kg/m
With the device turned OFF, directly add the salt in to the pool and keep the filtration run-
ning for 24 hours. Then turn on the device.
5

PARAMETERS SETTING

5.1. Control panel

A) Alarm light
B) Chlorine production %
C) Navigation key UP
D) Navigation key DOWN
5.2. ON/OFF functions
To start the device and settle the chlo-
rine production, press the key (C)
Press the (D) key to stop the device.
The (A) led will turn on. After 5 min. the device is on "stand by" mode, and the led will switch off.
5.3

Self-cleaning of the cell

This device is fitted with a polarity inversion system on the cell's poles that cleans the cell. The po-
larity inversion is automatic, every 4 hours and at each start up of the device.
Important
The automatic cleaning of the cell cannot compensate for the hardness of the water. If
TH is higher than 60°f, it is important to balance the water and lower its hardness.
MV-1810-03-2018 . © All rights reserved Swim & Fun Scandinavia ApS
)
3
0
0,5
1
1,5
2
2,5
3
3,5
4
4,5
Pool's water volume (m
10
50
45
40
50
30
25
20
15
10
5
A
OFF
20
)
3
20 30
100 150
90 135
80 120
100 150
60 90
50 75
40 60
30 45
20 30
10 15
40 60 80
C D
B
100
49