Preparation; Checking The Water Parameters - Swim & Fun Easy Salt 30 m2 Bedienungsanleitung

UK
Controller Box
Install the controller box vertically thanks to the wall support supplied. Do not cover and please pro-
tect it from the sun and the rain.
The controller must be permanently connected to the pump Timer. Do not use an extension cord.
Do not plug the device into an electric power outlet. Beforehand, turn off the differential circuit
breaker. Ensure that the controller box switches off when the filtration pump stops.
Beware:
Any contact between the controller box and the water of the pool can entail a risk of
electrocution.
Chlorinator cell
• Install the cell horizontally and after any other device of treatment, cleaning or heating (just be-
fore the water jet).
• Connect the cell supply cable to the controller box:
• Position the 2 terminals (Brown and Blue) indifferently on one of the borders of cell.
• Install the lock washers and the nuts, and then tighten nuts (using a size 10 spanner), gently,
until they block.
Beware:
An incorrectly connected cell may result in damage or destruction of the system, and
are not covered under warranty.
4.

PREPARATION

You have to make these operations before starting the device!

4.1 Checking the water parameters

During the device installation or before the early season, it is imperative to check and correct all
the following points:
State of the water
Water temperature
MV-1810-03-2018 . © All rights reserved Swim & Fun Scandinavia ApS
Clear, free from seaweeds and sediments.
Must be superior to +15°C
Important: Any use under this temperature entails accelerated wear of the cell
and entails the annulation of warranty. The system must be shut off when the
temperature is below +15°C
47