Atag OX6492F Bedienungsanleitung Seite 192

CLEANING AND CARE
EN 46
Changing the lamp
• Danger of electric shock!
Before replacing any of the oven light bulbs, take the following steps:
1. Switch off the oven.
2. Disconnect the oven from the mains.
3. Protect the oven light bulb and the glass cap by laying a cloth on
the bottom of the oven compartment.
Bulbs can be purchased from the ATAG Customer Service.
Replacing the rear oven lamp and cleaning the glass cap
1
Remove the cap by turning anticlockwise
and remove the metal ring, the sheet ring
and clean the glass cap. If necessary,
replace the bulb with a 25 watt, 230 V, 300
°C heat-resistant oven light bulb.
Clean the glass cap, the metal ring and
the sheet ring if necessary.
2
Fit the metal and the sheet ring to the
glass cap.
Place the glass cap where you have
removed it in step 1 and turn it clockwise
to keep it in place.