General Features; Tools Needed - Johnson Controls TM-3100 Installationsanleitung

English
READ THIS INSTRUCTION SHEET AND THE SAFETY
WARNINGS CAREFULLY BEFORE INSTALLING AND SAVE
IT FOR FUTURE USE

General Features

The Johnson Controls TM-3100 Series Room Temperature
Sensor provide passive sensing of temperature in HVAC
application. The TM-3100 is equipped with a Pt1000 Class A
sensing element and provides an output proportional signal to
the measured ambient temperature. The TM-3100 Series
Room Temperature Sensor is designed for use with the Facility
Explorer Series and with the Field Equipment Controller Series.

Tools Needed

• Flat-head screwdrivers (3 mm and 5 mm)
• Drill, bits, and appropriate 4 mm screws and plugs
• Pointed tool (available from Johnson Controls, Ordering Code
TM-9100-8900)
Figure 1: Dimensions (in mm)
Mounting
The TM-3100 Series Room Temperature Sensor is designed for
wall mounting in the room to be controlled. It should be placed
where the temperature is representative of the general room
conditions. Cold or warm air draughts, radiant heat and direct
sunlight should be avoided.
The installation of electrical wiring must conform to local codes
and should be carried out by authorized personnel only.
Users should ensure that all Johnson Controls products are
used safely and without risk to health or property.
This document is subject to change without notice
Figure 2: Removing Cover from Base
Remove the base of the module from the cover by inserting a
pointed tool (a special tool, Ordering Code TM-9100-8900, is
available from Johnson Controls) into the small hole at the
center top of the cover. While pressing down gently, prise the
base away from the cover. As the two parts separate, remove
the tool and continue to pull the cover away from the base until
the cover is free.
Figure 3: Module Base
Mount the base on the wall to cover the electrical output and
secure with at least two screws.
For other mounting options, see "Ordering Codes" and refer to
the corresponding installation sheets.