Safety Instructions - Nilfisk-Advance Gerni 642 Betriebsanleitung

For the benefit of the operator and his/hers surroundings, the fol-
lowing safety instructions must be carefully observed.
1. The high pressure cleaner must be earthed according to
regulations. To ensure reliable operation, the earth con-
nection contact resistance must not exceed 50 ohms.
2. Never exceed the maximum pressures and temperatures
indicated on the machine plate.
3. In case of operational failures and repair - switch off the
high pressure cleaner at the main switch and turn off the
water supply.
4. After operation - switch off the high pressure cleaner at
the main switch and turn off the water supply. Always
lock the pistol with the safety device on the trigger when
you leave the high pressure cleaner.
5. Use only Gerni A/S / NILFISK high pressure hoses. Do
not use non-Nilfisk-Advance high pressure hoses as they
do not comply with the safety standards required by
Gerni A/S / Nilfisk-Advance A/S. Never attempt to repair
defective high pressure hoses yourself.
6. The water jet is delivered from the nozzle at high speed.
Therefore, never aim the jet in the direction of people,
animals, electric installations or electrical conductors.
28

SAFETY INSTRUCTIONS

7. Leaks may be dangerous - contact our service depart-
ment.
8. It is recommended that protective clothing be worn to
avoid accidental spraying of unprotected skin.
9. Lance and pistol should always be held with both hands.
10. Never attempt to exchange the pistol or disconnect the
hoses before the high pressure cleaner has been
switched off and the pressure has been relieved.
11. Never allow children or unauthorized personnel to oper-
ate the high pressure cleaner.