Measurement With The Desired Systolic Pressure; Notes For Proper Measurement - A&D UA-851 Bedienungsanleitung

Measurement With The Desired Systolic Pressure

If your systolic pressure is expected to exceed 230 mmHg, use this
procedure.
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the
Release the button when the average
of all the data in memory is displayed.
Press and hold the START button
again until a number about 30 to 40
mmHg higher than your expected
systolic pressure appears.
3. Release the
measurement,
number is reached. Then continue to
measure your blood pressure as
described on the previous page.

Notes For Proper Measurement

Sit down in a comfortable position. Place
the arm to be used for the measurement
on a table or other support so that the
center of the cuff will be at the same
height as your heart.
Relax for about five or ten minutes before taking a measurement. If you
are excited or depressed by emotional stress, the measurement will
reflect this stress as a higher (or lower) than normal blood pressure
reading and the pulse reading will usually be faster than normal.
An individual's blood pressure varies constantly, depending on what you
are doing and what you have eaten. What you drink can have a very
strong and rapid effect on your blood pressure.
This device bases its measurements on the heartbeat. If you have a very
weak or irregular heartbeat, the device may have difficulty determining
your blood pressure.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. Refer to page 4 for the
description of the symbols.
This blood pressure monitor is intended for use by adults only. Consult
with your physician before using this device on a child. A child should not
use this device unattended.
Measurements
START
button to start
START
when the
English 10
button.
Press and hold the button
Release the button
when the average
Press and hold the button
desired
Release the button
systolic pressure
Refer to the previous page
At heart level
is displayed.
Starts inflation
at the desired
for measurement
START
START