Measurements; Normal Measurement - A&D UA-851 Bedienungsanleitung

Model UA-851 is designed to detect the pulse and to inflate the cuff to a
systolic pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg, read
"Measurement With The Desired Systolic Pressure" on the next page.

Normal Measurement

1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the
START
All of the display segments are displayed.
Then, 0 (zero) is displayed blinking briefly.
Then the display changes, as indicated in
the figure at the right, as the measurement
begins. The cuff starts to inflate. It is
normal for the cuff to feel very tight. A
pressure bar indicator is displayed, as in
the figure at the right, during inflation.
Note: If you wish to stop inflation at any time,
press the
3. When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4. When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5. Press the
START
the power.
Note: The device has an automatic power shut-off function, which turns the
power off automatically one minute after measurement.
Allow at least ten minutes between measurements on the same person.

Measurements

button.
button again.
START
(heart mark) blinks,
button again to turn off
English 9
At heart level
Press
All of the display
segments displayed
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
air automatically
START