Attaching The Arm Cuff; How To Take Proper Measurements; Measurement; After Measurement - A&D UA-767 Plus 30 Bedienungsanleitung

Attaching The Arm Cuff

1. Wrap the cuff around the upper arm,
about 2 - 3 cm above the elbow, as
shown. Place the cuff directly against
the skin, as clothing may cause a faint
pulse and result in a measurement
error.
2. Constriction of the upper arm, caused
by rolling up a shirtsleeve, may prevent
accurate readings.
3. Confirm that the index
the proper fit range.

How To Take Proper Measurements

For the most accurate blood pressure

measurement:

Sit comfortably at a table.
Rest your arm on the table.
Relax for about five to ten minutes
before measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath. Rest for twenty or
thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.
Measurement
During measurement, it is normal for the cuff to feel very tight. (Do not be
alarmed)

After Measurement

After measurement, press the
Remove the cuff and record your data.
Note: The device has an automatic power shut-off function, which turns the
power off approximately one minute after measurement.
Allow at least ten minutes between measurements on the same person.
Using the Monitor
points within
English 7
Rolled up shirtsleeve
Constriction of the Upper Arm
Index
button to turn off the power.
START
Cuff
Air Hose
2 -3 cm
and Proper fit range