Idegis D-10 Bedienungsanleitung Seite 43

PRODUCTION CONTROL
Power level: indicates the output power
(voltage) level of the power supply. The chlorine
production obtained in each level depends on the
concentration of salt and temperature of the water.
Up: when this key is pressed, the power supply
increases one level of power output.
Down: when this key is pressed, the power
supply decreases one level of power output.
Production indicator: indicates the system
chlorine production expressed as percentage of its
nominal capacity (see section 1,3). Although the
salt electrolysis system is designed to work in all
the production range, it is recommended to work
in the "Normal" band (80-100%).
RESET / AUTO FUNCTION:
RESET Function: the system enters in "stand-by"
mode when this key is pressed. It also allows
rearming the power supply when the system is in
"stand-by" due to an overload situation
("overload").
AUTO Function: maintaining this key pressed
during 3 seconds, when the power supply is in
"stand-by", the power supply enters in AUTO
MODE. In AUTO MODE, the output power level is
automatically adjusted to reach the 100% of
production. In order to deactivate the AUTO
MODE, just press this key again.
8