Südwind AMBIENTIKA SOLO Handbuch Für Installation Und Wartung Seite 63

C IG R I
o set up the product to be used as M S R unit, turn on the power of this b means of the main
switch 0 and, once it is powered, if there is no product connected and switched on at C and
C2, this will be configured as M S R after the first 0 seconds during which the red L D indicator
will remain stead .
nce the red L D is turned off, press
mode, the product is configured correctl as M S R.
nl when the product is identified as the main unit M S R, ou can start configuring SL
D S D
Make sure that the M S R unit starts its operation before turning the next unit SL
switch 0 , so as to leave the M S R unit time to set up the SL
se uence.
sing switch 0 , turn the SL
ach unit must be turned on onl after the previous unit has actuall started its operation.
Master unit
2 Slave with operation opposed to Master
Slave 2 with operation identical to Master
4 Slave with operation opposed to Master...
I
If the product is not set up properl M S R or SL
restore the product to its default conditions - this process is explained in the remote controller
manual.
H M S R - SL
R M C MM D
units on se uentiall , as explained below.
PR D C S R H
if the L D gives the signal corresponding to the
H SL PR D C S
, it is possible to use the R S
D C D RSI
products in the desired
.
on via
function to
15