Südwind AMBIENTIKA SOLO Handbuch Für Installation Und Wartung Seite 54

1) SS MBL
fter having identified the area intended to the product installation, mark the center of the hole to
be made on the wall.
Make sure that, with respect to the center of the hole for the recessed tube, there is free space on
the internal and external walls for a radius of 5 cm from the center - these correspond to the
volume of the product. Make sure, therefore, that within this area, there is no interference with
non-removable walls and ob ects.
he diameter of hole to be made is
he hole made in the wall must be a through one and with an inclination of
order to be able to use the recessed tube supplied, the wall thickness must not exceed
mm. he wall intended to the product installation must not be less than 250mm thick. nce the
through hole in the wall is formed, place the recessed tube within
Make sure that the length of the recessed tube
he tube must end flush with the surfaces of the internal and external walls.
he M uote can not be less than 250mm - in this case, the wall provided is not suitable to the
product installation.If necessar , ad ust the tube to the wall thickness with appropriate tools, in a
timel manner, as shown below
0mm.
is e ual to the wall thickness.
- 2 outwards. In
.
7