Cardin Elettronica SL Serie Bedienungsanleitung Seite 85

MEMORISING MORE TRANSMITTERS BY USING A PREVIOUSLY MEMORISED TRANSMITTER S504 - S508
This procedure allows you to enable a new transmitter (from a remote position) with the help of a transmitter that has already been memorised in the
system. As the presence of the receiver is not required this procedure can be carried out in any remote location (for example in your chosen sales
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
outlet).
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
Access to the 'rapid memorizing' procedure is possible if the parameter 5p has been activated via the menu
REMOTE MEMORISE OPTIONS
on the electronic programmer.
All rights reserved. Unauthorised copying or use of the information contained
1) Remove the upper cover from the transmitter to be memorised and from the transmitter that has already been memorised as shown in the drawing
below (det. a).
2) Place the transmitter A, that has already been memorised in the receiver, beside the new transmitter B (det. b).
3) Using a pointed object press and release the MR button on both transmitter (in sequence or simultaneously).
4) The orange LEDS on the transmitters will flash slowly.
5) Press and release a channel button on transmitter A that is already present in the receiver (det. c).
6) The LED of the new unit B will remain lit for 3 seconds to confirm that the transmitter has been accepted (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
1
2
MR
B
4
A
A B
3
85