G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LWG 8 Originalbetriebsanleitung

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LWG
8.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine ist intended for the cutting, grinding and
brushing of metal and stone materials. The machine is
intended exclusively for 2-hand working operattions.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH, Trottäcker 50, D-79701 Bad Säck-
ingen, hereby declares under sole responsibility that
the product with the serial or batch no. (see reverse
side) complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
08/2017.
M. Voyame/Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Use oiled compressed air (see also air quality un-
der section 2.3). Observe national regulations.
2.2 t
AKing the mAchine into serVice
2.2.1 /t
turn on urn off
Tilt lock forward an press lever onplastic sleeve. Releas-
16
S
oteS on afety
ommISSIonIng
ing the lever switches the machine OFF.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
Wheel diameter
Spindel thread
Length of spindle thread stud
No-load speed
Sound pressure level EN ISO 15744 76dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 P
rotection deVices
The machine may only be operated with the safety
guards and the additional handle fitted!
3.1.1 s
Afety guArd
The safety guard was already correctly adjusted in
the factory.
s
et Position
Press locking mechanism and rotate safety guard to de-
sired position.
max. 6.3bar
900W
3
1.1m /min
3
0.6m /min
2-3 drops/min
max. 115mm
M14 / 5/8"
18mm
-1
7'500min
2 2
4.4m/s , K=1.5m/s
3/4/4
1.5kg
/o
peratIon