SYNQ AUDIO RESEARCH SMX.2 Bedienungsanleitung Seite 11

ENGLISH
HOW TO UPGRADE THE PROCESSOR SOFTWARE:
 Put the SD™-card in your PC and copy the file called "mcu.bin" to the memory card.
Important! Do NOT rename the file!
 Put the SD™-card in the memory slot (28) on the SMX-2.
 Switch the mixer off.
 Press the 3 play buttons (23) marked "2" + "4" + "8" together.
 Turn the mixer on while you keep the 3 buttons pressed.
 All CUE buttons (5) flash four times to indicate that the upgrading process has started.
Once all cue buttons flashed 2 times you can release the 3 play buttons.
You will notice that the CUE buttons will lighten one by one (from 1 to 5) while the play
buttons change colors. After about 25seconds the display returns to normal to indicate that
the upgrading process has ended.
 Check the software version to see if the upgrading process succeeded.
HOW TO UPGRADE THE DSP SOFTWARE:
 Put the SD™-card in your PC and copy the file called "dsp.bin" to the memory card.
Important! Do NOT rename the file!
 Put the SD™-card in the memory slot (28) on the SMX-2.
 Switch the mixer off.
 Press the 3 play buttons (23) marked "8" + "16" + "32" together.
 Turn the mixer on while you keep the 3 buttons pressed.
 All CUE buttons (5) flash four times to indicate that the upgrading process has started.
Once all cue buttons flashed 2 times you can release the 3 play buttons.
You will notice that the CUE buttons will lighten one by one (from 1 to 3). After about
15seconds the display returns to normal to indicate that the upgrading process has ended.
 Check the software version to see if the upgrading process succeeded.
SYNQ® 17/119
OPERATION MANUAL
SMX-2
ENGLISH
CHANGING THE FADERS
One of the big advantages of this mixer is the possibility to change the channel faders,
even while the mixer is in use.
This is what you must do to change a channel fader:
 Remove the fader knobs from the faders.
 Remove the 6 screws that hold the small
front panel around the faders.
 Remove the 3 screws of the fader you
want to change.
 Gently remove the fader from its position.
 Put the new fader gently in place. Be sure
to fit the contacts into the connector on
the mixer PCB-board.
 Put the 3 screws from the fader back in
place
 Put the small front plate back in place
with the 6 screws.
Done!
This is what you must do to change the cross fader:
 Remove the fader knob from the cross fader.
 Remove the 2 screws that keep the cross fader in place.
 Gently remove the fader and the cover plate from their position.
 Unplug the cross fader from the cable (unplug the cable by pulling the connector, NOT
the cable!)
 Press the new cross fader on the cable.
 Put the cross fader back in place with the small cover plate and the 2 screws.
Done!
SYNQ® 18/119
OPERATION MANUAL
SMX-2