Maintenance; Controls - Grundig RR 630 CD Handbuch

MAINTENANCE

General
• The mechanical parts of the CD player and the cassette deck
contain self-lubricating bearings and must not be oiled or
lubricated.
• A chamois leather slightly moistened with water is sufficient
GB
for cleaning the housing.
• Do not use cleaning agents as these may harm the housing.
• Do not leave the set, batteries, CDs or cassettes for any length
of time in direct sunlight or other places where high temperatures
can occur, such as in the vicinity of heating apparatus.
• Do not expose the set, batteries, CDs or cassettes to humidity
or rain.
Positioning the set
Caution should be exercised if the set is placed on furniture as
surfaces are often coated with lacquers and plastic finishes
containing additives which attack the material of which the feet
of the set are made, leaving stains which can only be removed
with difficulty or not at all.
CD player maintenance
• The lens X must not be cleaned.
• This product should be used in dry and closed rooms. The
lens may cloud over if the CD player is moved from cold to
warm surroundings. The CD player will not start. Do not
clean the lens, but give the player some time to acclimatise.
Cassette deck maintenance
To ensure a good recording and playback quality, clean the
indicated parts ABC after every 50 hours of operation or, on
average, once a month.
• Open the cassette holder using 9//.
• Use a cotton bud slightly moistened with alcohol or a special
head cleaning fluid.
• Press B and clean the rubber pressure rollers C.
;
• Then press and clean the capstans B and the heads A.
• After cleaning, press 9//.
• Cleaning of the heads A can also be done by playing a
cleaning cassette through once.
12
This unit meets the CEE
regulations concerning
interference radiation.
This product fulfills European
directives 89/336/EEC,
73/23/EEC and 93/68/EEC.
This unit complies with the safety
regulations according to VDE
0860 / BS 415 and thus with the
international safety regulation
according to IEC 65.
The type plate is located at the
bottom of the set.
X
A A B C

CONTROLS

CD Remote control (only RR 660 CD)
Two batteries 1.5 Volt LR03 size AAA are
required. To change the batteries, open the
compartment on the back of the remote control.
Ensure that the batteries are inserted properly (note
the markings in the compartment).
And in the interest of the environment: Remember
that batteries must always be disposed of properly.
PLAY/PAUSE 2; – to start and interrupt CD playback
STOP 9
– to stop CD playback
R-SKIP 5
– to skip and search backward
F-SKIP 6
– to skip and search forward
# VOLUME $ – to adjust the volume
MODE – CD in stop mode: to programme
track numbers in the memory
– CD during playback: to repeat
one/all tracks or to play the titles
of a CD in random order
Changing the
batteries
If the range of
your infrared
remote control
seems to
decrease, or if
certain individual
functions can no
longer be carried
out, you should
replace the
batteries.