Maintenance - Grundig RR 300 CD Bedienungsanleitung

General
• The mechanical parts of the CD player and the
cassette deck contain self-lubricating bearings
and must not be oiled or lubricated.
• A chamois leather slightly moistened with water
GB
is sufficient for cleaning the housing.
• Do not use cleaning agents as these may harm
the housing.
• Do not leave the set, batteries, CDs or cassettes
for any length of time in direct sunlight or other
places where high temperatures can occur, such
as in the vicinity of heating apparatus.
• Do not expose the set, batteries, CDs or cassettes
to humidity (e.g. dripping or splashing) or rain.
CD player maintenance
• The lens X must not be cleaned.
• The lens may cloud over if the CD player is
moved from cold to warm surroundings. The CD
player will not start. Do not clean the lens, but
give the player some time to acclimatise.
Cassette deck maintenance
To ensure a good recording and playback quality,
clean the indicated parts ABC after every 50
hours of operation or, on average, once a month.
• Open the cassette compartment using 9//.
• Use a cotton bud slightly moistened with alcohol
or a special head cleaning fluid.
• Press A and clean the rubber pressure rollers C.
;
• Then press and clean the capstans B and the
heads A.
• After cleaning, press 9// and
• Cleaning of the heads A can also be done by
playing a cleaning cassette through once.
12

MAINTENANCE

X
;
.
CLASS 1
LASER PRODUCT
C B A A
Warning
CLASS 1 LASER PRODUCT
means that the laser´s construction makes it
inherently safe so that the legally prescribed
maximum permissible ratiation values can never
be exceeded.
CAUTION: Using any equipment or devices
other than those described and specified in these
operating instructions, or tampering with the unit
in any way, can result in dangerous exposure to
radiation.
Positioning the set
Caution should be exercised if the set is placed
on furniture as surfaces are often coated with
lacquers and plastic finishes containing additives
which attack the material of which the feet of the
set are made, leaving stains which can only be
removed with difficulty or not at all.
This unit meets the CEE regulations concerning
interference radiation.
This product fulfills European directives
89/336/EEC, 73/23/EEC and 93/68/EEC.
This unit complies with the safety regulations
according to VDE 0860 / BS 415 and thus
with the international safety regulation
according to IEC 65.
The type plate is located at the bottom of the set.