Schumacher SPI1224 Benutzeranleitung Seite 8

CHARGING
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in sections 6 and 7.
3. Connect the AC power following the precautions listed in section 8.
4. After AC is connected, display will show SELECT CHARGE MODE. Press button once
to enter 12V charge mode, press button once again to enter 24V charge mode. When
charging starts, the GREEN LED will be solid, and the display will show ANALYZING
12V BATTERY or ANALYZING 24V BATTERY while the charger determines that the
battery is properly connected and the condition of the battery.
5. When the battery is fully charged, the GREEN LED will pulse.
6. When charging is complete, disconnect the AC cord from the supply mains, remove the
clamp from the vehicle's chassis, and then remove the clamp from the battery terminal.
RECONDITION
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in sections 6 and 7.
3. Connect the AC power following the precautions listed in section 8.
4. After AC is connected, display will show SELECT CHARGE MODE. Press button once
to enter 12V charge mode first, then double click button to enter 12V Recondition mode.
Press button once again to enter 24V charge mode. When charge starts, the display
will show RECONDITION TIME REMAINING XXX MINUTES. If the recondition is
successful, the display will show RECONDITION SUCCESSFUL - START NORMAL
CHARGING, If the recondition is unsuccessful, the display will show CHARGE
ABORTED-BAD BATTERY, and the GREEN LED will flash.
5. When the battery is fully charged, the GREEN LED will pulse.
6. When charging is complete, disconnect the AC cord from the supply mains, remove the
clamp from the vehicle's chassis, and then remove the clamp from the battery terminal.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not start and the
digital display will show one of these messages:
12V-CONNECT CLAMPS- PRESS FOR 24V-DOUBLE FOR RECONDITION
12V-RECONDITION CHARGE-PRESS FOR 24V-DOUBLE FOR REGULAR
24V-CONNECT CLAMPS- PRESS FOR 12V-DOUBLE FOR RECONDITION
24V-RECONDITION CHARGE-PRESS FOR 12V-DOUBLE FOR REGULAR
Make sure the charger is connected to the battery and the connection points are clean and
making a good connection. If the display shows WARNING-CLAMPS REVERSED, unplug
the charger from the AC outlet, reverse the connections at the battery, and then plug the
charger back in.
BATTERY CHARGING TIMES
CCA = Cold Cranking Amps
BATTERY
APPLICATION
POWERSPORTS
AUTOMOTIVE 300 CCA
1000 CCA
MARINE
230 Ah
Times are based on a 50% discharged battery and may change,
depending on age and condition of battery.
Ah = Amp Hour
CHARGING TIME (hours)
SIZE 6A 10A
6 Ah 2 1.5
32Ah 5 4
4 3
10 7
50 Ah 5 3.5
19 11.5
12A 15A
1 0.5
NOT
RECOMMENDED
3 2
2 1.5
5.5 4
2.5 2
9.5 7.5
• •
8