Maintenance Instructions; Moving And Storage Instructions - Schumacher SPI1224 Benutzeranleitung

RECONDITION TIME REMAINING XXX MINUTES – Recondition mode has started. The
remaining time on the display counts down from 180 minutes.
RECONDITION SUCCESSFUL-START NORMAL CHARGING – Shows on display for
60 seconds after a successful Recondition.
WARNING-CLAMPS REVERSED (No LED lit) – The output clamps are connected
backwards to a battery.
ANALYZING 12V BATTERY (Green LED lit) – Plugged into the AC outlet, and when first
correctly connected to 12V battery at 12V charge mode.
ANALYZING 24V BATTERY (Green LED lit) – Plugged into the AC outlet, and when first
correctly connected to 24V battery at 24V charge mode.
CHARGING 12V – xx% (Green LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 12V battery at 12V charge mode.
CHARGING 24V – xx% (Green LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 24V battery at 24V charge mode.
FULLY CHARGED-AUTO MAINTAINING (Green LED pulsing) – Plugged into the AC
outlet and correctly connected to a fully charged battery.
CHARGE ABORTED-BAD BATTERY (Green LED flashing) –
Circumstances that could cause an Abort situation during charging:
• The battery is severely sulfated or has a shorted cell and can't reach a full charge.
• The battery is too large or there is a bank of batteries and it doesn't reach full charge within
a set time period.
Circumstances that could cause an Abort situation during maintain:
• The battery is severely sulfated or has a weak cell and will not hold a charge.
• There is a large draw on the battery and the charger has to supply its maximum maintain
current for a 12 hour period to keep the battery at full charge.
• Recondition mode is unsuccessful.
BATTERY DISCONNECTED (No LED lit) – After charging has begun, the charger has lost
its connection to the battery.
OFF (No LED lit) – During the charge process or Recondition process, press the button once to
stop the charge or recondition. The display will show OFF and then SELECT CHARGE MODE.

14. MAINTENANCE INSTRUCTIONS

14.1 Cleaning and user maintenance should not be done by children without supervision.
14.2 After use and before performing maintenance, unplug and disconnect the battery charger
(see sections 6, 7 and 8).
14.3 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery
connectors, cords, and the charger case.
14.4 Ensure that all of the charger components are in place and in good working condition, for
example, the plastic boots on the battery clips.
14.5 Servicing does not require opening the unit, as there are no user-serviceable parts.
14.6 All other servicing should be performed by qualified service personnel.
14.7 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons, in order to avoid a hazard.

15. MOVING AND STORAGE INSTRUCTIONS

15.1 Store the charger unplugged, in an upright position. The cord will still conduct electricity
until it is unplugged from the outlet.
15.2 Store inside, in a cool, dry place.
15.3 Do not store the connectors clipped together, on or around metal, or clipped to cables.
15.4 If the charger is moved around the shop or transported to another location, take care to
avoid/prevent damage to the cords, connectors and charger. Failure to do so could result
in personal injury or property damage.
• •
10