Using The Camera - Canon WP-DC42 Benutzerhandbuch

Using the Camera

Please refer to the Camera User Guide for instructions
on how to use the camera.
Underwater Mode
Setting the camera to S mode will tone down the
blues, letting you obtain more natural colors when
shooting underwater.
1
Set the mode dial to K.
2
After pressing the m button, press the
op buttons to choose
the m button again.
3
Press the op buttons to choose S ,
then press the m button.
10
Using the Control Dial
When the camera is inserted into the case, control dial
operations can be used by the following method:
•
However, if you press the l button only for more
than 2 seconds, the screen increases to maximum
brightness. To restore the normal brightness, press the
l button for more than 2 seconds again.
Mode Dial
Using the GPS Function
(PowerShot SX230 HS Only)
When using the Waterproof Case, it may be difficult
for the camera to receive the the GPS satellite signal.
Additionally, when underwater or when the case is
wet, the camera may not receive the signal.
, then press
• When shooting underwater in
D modes, you should set the white balance to S
(Underwater) using the FUNC. menu.
l button, then move the
Press and hold the
zoom lever toward i or j .
E , G , M , B or