List Of Messages - Noritsu IP-64 Bedienungsanleitung

List of Messages

Messages appear on the LCD under the following
conditions. Please take the remedial actions shown next
to the message to correct the problem.
Messages and error messages causing
the ALARM indicator to turn on
When the ALARM indicator on the front panel lights in
red, a message or an error message appears on the LCD.
Please take the remedial actions shown next to the
message to correct the problem.
Message Description and Remedy
CHECK PAPER Paper corresponding to the designated
number of sheets has been used up.
tLoad a new ink ribbon and paper
roll (page 44).
CHECK PAPER & • Paper cannot be fed or ejected
RETRY correctly.
tLoad the paper roll correctly
• The end of the paper may be folded
or bent.
tCheck whether or not the paper
CHECK RIBBON • The ink ribbon may have broken.
tRepair it with adhesive tape
• Ink ribbon corresponding to the
designated number of sheets has
been used up.
tLoad a new ink ribbon and paper
• The ink ribbon is not loaded
correctly.
tLoad it correctly (page 44).
DOOR OPEN The front door is open.
tClose the front panel until it is
locked securely (page 50).
MECHA TROUBLE Mechanical trouble has occurred in the
printer.
t Contact your place of purchase.
MEDIA MISMATCH An incompatible ink ribbon and paper
roll are loaded.
tLoad the compatible ink ribbon and
paper roll taken from the same
package (page 65).
NO PAPER There is no paper roll loaded.
tLoad a paper roll (page 44).
NO RIBBON There is no ink ribbon loaded.
tLoad an ink ribbon (page 44).
PAPER END Paper corresponding to the designated
number of sheets has been used up.
tLoad a new ink ribbon and paper
roll (page 44).
(page 47).
is folded or bent. If it is, cut the
folded part of the paper off and
load the paper roll again
(page 47).
(page 52).
roll (page 44).
Message Description and Remedy
RIBBON END Ink ribbon corresponding to the
designated number of sheets has been
used up.
tLoad a new ink ribbon and paper
roll (page 44).
RIBBON ERROR Something is wrong with the data on
the IC seal attached to the ink ribbon.
tReplace the ink ribbon and paper
roll with a new ink ribbon and
paper roll (page 44).
Other messages
When the following messages appear even though the
ALARM indicator does not light, take the remedy next
to each message.
Message Description and remedy
HEAD IN COOLING The thermal head is too hot.
tWait for the message to disappear.
Printing will then resume
automatically.
PLEASE WAIT The printer has ejected a printout
because it has received a stop
command or the printer has stopped
printing due to some problem.
tWait for the message to disappear.
67
List of Messages