Attaching The Paper Holders To The Paper Roll - Noritsu IP-64 Bedienungsanleitung

Attaching the Paper Holders to the
Paper Roll
A pink paper holder and a blue paper holder are supplied
with the printer. Attach them to the new paper roll, and
then load the paper roll.
When you use the printer for the first time, start the
operation from step 1 to remove paper holders which
were placed in the printer at the factory.
If you have already removed the paper holders, start the
operation from step 4.
1
Pull the lock lever for the front door toward you to
open the front door.
2
Pull the lock lever for the ribbon base located on the
front of the ribbon base and pull up the ribbon base.
3
Pull the paper cartridge of the printer toward you.
Take out the packages in which the paper holders
are stored inside the printer.
Then, close the front door in the reverse operation.
4
Adjust the length of the blue paper holder.
There are two kinds of paper. One is paper with
127-mm (5-inch) width and the other is paper with
152-mm (6-inch) width.
The blue paper holder has been pre-adjusted for
paper with a 152-mm (6-inch) width.
Paper with 127-mm (5-inch) width: 2YNR-
R153 and 2YNR-R155 Printing Pack
Shorten the length of the blue paper holder.
Loading the Paper Roll and Ink Ribbon
45