Menu Operations; Preparation For Menu Operation - Noritsu IP-64 Bedienungsanleitung

Once printing has been completed, READY
appears on the LCD again.
Note
Do not leave more than 30 sheets of printouts on the
paper tray when using the 2YNR-R153 or 2YNR-R154
Printing Pack. Do not leave more than 20 sheets of
printouts on the paper tray when using the 2YNR-R155
or 2YNR-R156 Printing Pack. However, the number of
printouts which can be accumulated on the paper tray
changes according to the environment condition where
the printer is used or the printed image. Remove the
printed sheets accumulated on the paper tray as soon as
possible.
Adjust the length of the paper tray according to the
Printing Pack to be used.
For details, see "Attaching the Paper Tray" on page 51.
To stop printing midway
Press and hold the PRINT STOP button for more than
one second. The page currently being printed is
completed and ejected. After the printout is ejected, the
information display returns to READY. The image data
stored in the memory and the number of printings set in
the queue are cancelled.
Memory capacity
Image data transferred from the computer is stored in the
memory of the printer. Data for one more image can be
stored in addition to that of the one being printed.
If the printer does not print
When an error message is displayed on the LCD, you
cannot operate the printer. Take remedies according to
the advice given in "List of Messages" on page 67.
Notes on storing your printouts
• Avoid exposure to direct sunlight, or conditions of
high temperature and high humidity, which could
cause the colors to fade.
• Avoid applying tape to a printout, and avoid contact
with plastic objects such as erasers and desk mats.
• Do not allow absolute alcohol or other volatile organic
solvents to come into contact with the printouts.
56

Menu Operations

Menu Operations
You can adjust or confirm the following items using the
menu.
• Adjustment of the gray balance
• Display of the total quantity of pages printed
• Display of the firmware version of the printer

Preparation for Menu Operation

The MENU button allows you to carry out menu
operations. Buttons to be used for menu operation,
including the MENU button, are located under the front
panel. Usually these buttons are hidden under the front
panel. To use them, you have to remove the front panel.
1
Remove the lower part of the front panel and pull it
upward to remove the front panel completely.
The key panel section appears.
2
Carry out the operation using these buttons
including the MENU button.