Zanussi zbt3204 Benutzerhandbuch Seite 22

Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of right
hinge, SX in opposite case.
Ha
Hc
Push the part (Hc) on the
part (Ha).
Hb
Hd
Press the part (Hd) on the
part (Hb).
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.
22
C
D
E
E
B
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers (E)
to the hinge.
8 mm
Ha
Hb
Open the appliance door
and the kitchen furniture
door at an angle of 90°.
Insert the small square (Hb)
into guide (Ha).
Put together the appliance
door and the furniture door
and mark the holes.
Ha Hb
Hc
Hd
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
8 mm
K
Ha
Remove the brackets and
mark a distance of 8 mm
from the outer edge of the
door where the nail must be
fitted (K).
Important! If the ambient temperature is low (for example,
in the Winter), the size of the gasket decreases. The size
of the gasket increases when the ambient temperature
increases.
ca. 50 mm
90°
21 mm
90°
ca. 50 mm
21 mm
Install the part (Ha) on the
inner side of the kitchen
furniture.
Hb
Place the small square on
the guide again and fix it
with the screws supplied.
Align the kitchen furniture
door and the appliance
door by adjusting the part
Hb.