Herunterladen Inhalt Inhalt Diese Seite drucken

Repositioning The Door; Appliance Maintenance And Cleaning - Beko CHA33100 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
GB
Advice for a maximum
efficiency
Important!
Do not introduce into the freezer a too big
quantity of food at a time. The quality of food
is best kept if it is frozen deeply as quick as
possible. This is why it is better not to exceed
the freezing capacity of the appliance
specified in the "Appliance data sheet". To
reduce the freezing time, you can use the
function „fast freeze".
Fresh food must not come into contact with
the food already frozen.
Frozen food, bought from the shop, can be
placed into the freezer without needing to
adjust the thermostat.
If the freezing date is not mentioned on the
packing, please consider a period of storage
of max. 3 months (as a general rule).
Any food, even partially defrosted, cannot be
frozen again, it must be consumed
immediately or cooked and then frozen again.
Fizzy drinks will not be stored in the freezer.
In case of a power failure do not open the
door of the appliance. The frozen food will not
be affected if the failure lasts less than 18
hours.
Energy saving
Avoid placing the appliance in a sunny area
or near a heat source.
Provide the good ventilation of the
compressor and condenser.
Place the food into closed vessels or foil to
avoid ice build-up.
Do not leave the doors open longer than
Instruction for use
6

Repositioning the door

Proceed in numerical order (Item 11).
Appliance maintenance and
cleaning
Advice for appliance defrosting
The „NO FROST" defrosting is completely
automatic. You do not need to do anything.
The water from the defrosting is collected in a
tray on the compressor, where it evaporates
because of the temperature generated during
its operation (Item 6).
Keep clean the collector and the water drain
tube. For this purpose use the supplied trench
part. Check that the tube is permanently
placed with its end in the collecting tray on the
compressor to prevent the water spilling on the
electric installation or on the floor (Item 7).
Inside cleaning
(Item 8 & 9)
Before starting the cleaning operation, unplug
the appliance.
It is recommended that you clean the
appliance when you defrost it.
Wash the inside with lukewarm water where
you add a neutral detergent. Do not use soap,
detergent, petrol or acetone which can leave a
strong odour.
Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the water excess
to prevent it from entering into the thermal

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis