W Orking Instructions; Service & Maintenance; P Reventive Maintenance; R Eplacement Of The Exhaust Air Hose - SUHNER LFB 44-E Originalbetriebsanleitung

release/tighten down collet chuck with open end wrench
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move tool uni-
formly back and forth with light pressure. Excessive pres-
sure lessens the working capability of the machine, as
well as the life of the tool.
4. S
ervIce
4.1 P
reVentiVe mAintenAnce
Without a tool clamped in check no-load speed periodi-
cally and after each maintenance. Even if the machine still
operates perfectly, the motor should be removed, cleaned
and the four slides checked for wear by a specialist after
approx. 300 to 400 operating hours.
4.1.1 r
ePlAcement of the exhAust Air hose
Detach the exhaust air hose from the swivel ring, and re-
place it.
4.1.2 r
ePlAcement of the suPPly hose
Remove the exhaust air hose (see 4.1.1).
Detach the hose clamp, and pull the supply hose off the
connection nipple.
/m
aIntenance
13