Motor Overriding System; Installation Layout - V2 GOLD230V-D Anleitungen

MOTOR OVERRIDING SYSTEM

In case of a blackout, the gate can be operated directly from
the motor. Insert the key supplied in the lock 1 on the front
side of the motor, perform 1/4 of a turn and open the plastic
door completely.
To restore the automation, simply close the door, rotate the key
in closed position and slide the specially provided plastic cover
onto the lock.
WARNING: In case the leaf overruns its final position and
impacts against the safety stroke end (i.e. wrong regulation of
the limit switches),and a manual unclamp would be necessary,
before using the above procedure, you have to replace the leaf
setting away from the safety stroke end using the flat screw on
the main motor shaft 2 with a screwdriver.
Power supply
Blinker
External Aerial
Digital or key selector
Internal Photocellules
(type 1)
External Photocellules
(type 2)

INSTALLATION LAYOUT

cable 3 x 1,5 mm 2
cable 2 x 1,5 mm 2
cable RG-58
2
cable 2 x 1 mm
cable 4 x 1 mm 2 (RX)
cable 2 x 1 mm 2 (TX)
cable 4 x 1 mm 2 (RX)
cable 2 x 1 mm 2 (TX)
WARNING: ALL THE CABLES USED FOR THE
INSTALLATION MUST BE MARKED WITH T100°C.
27