Pd8 Function Table - V2 GOLD230V-D Anleitungen

DISPLAY DATA DESCRIPTION
dEF no / Si Select item Si to load the default values
t.AP 0.0" ÷ 2.0' Gate opening time
t.APP 0.0" ÷ t.AP1 Opening time of pedestrian gate
t.Ch 0.0" ÷ 2.0' Gate closing time
t.ChP 0.0" ÷ t.Ch Closing time of pedestrian gate
t.PrE 0.5" ÷ 2.0' Pre-flashing time
no - Pre-flashing disabled (it corresponds to 0)
dir Gate direction (the direction you see from the inside)
dx - The gate opens rightwards
Sx - The gate opens leftwards
Pot 30 ÷ 100% Motor power
SPUn no/Si Start off
t.P.So 0.5" ÷ 3.0" Slowed down starting time
no - Slowed down starting disabled
t.raL 0.5"÷22.5" Slow down time
no - Slow down disabled
St.AP Start in opening
no - Start command is not available
ChiU - Command close gate
PAUS - Stop the gate and goes in pause
St.Ch Start in closing
Stop - Start command stop the gate
APEr - Start command open the gate
St.PA Start in pause
no - Start command is not available
ChiU - Start command closes the gate
SPAP Pedestrian in opening
no - Pedestrian start command is not available
ChiU - Pedestrian start command closes the gate
PAUS - Gate goes in pause
Ch.AU Automatic closing
no - The gate closes after the setup time)
0.5"÷ 20.0' - The automatic closing is not active (it corresponds to 0)
Ch.tr Closing after passage
no - Closing after passage disabled
0.5"÷ 20.0' - Gate stop for a time to be set between 0.5" to 20'
LP.PA no/Si Flashlight in pause

Pd8 FUNCTION TABLE

42
DEFAULT MEMO
SCor DATI
no
22.5"
6.0"
23.5"
7.0"
1.0"
dx
60
no
1.5"
2.0"
PAUS
StoP
ChiU
PAUS
no
no
no