Troubleshooting; Problems And Solutions - Korg SV-1 Anleitung

34 – Troubleshooting | Problems and solutions

Troubleshooting

If you suspect a malfunction, please check the following points first. If this does not
resolve the problem, please contact your dealer or Korg Authorized Service Center.
Problem Possible remedy
The instrument will Check that the AC cable is not damaged, and it is correctly connected to the piano
not turn on and the outlet.
No sound Make sure that the volume is not set on 0. If it is, bring it up to an adequate level.
Make sure that the Local Off function is not turned on. If it is, turn it off.
If you are listening in headphones, make sure the jack is correctly plugged into the
HEADPHONES connector.
Make sure there isn't one of the following control settings:
• Pre-FX Comp: Intensity = 0
• Pre-FX Boost: Intensity = 0
• Amp Models: Drive = 0
The valve might still be "warming up". Please wait some seconds. This isn't a malfunc-
tion – it's a real analogue valve!
Something missing If you are using the XLR outputs, make sure you have connected both outputs. Mono
output is not possible with the XLR jacks.
Weak sound The valve may be exhausted. Please refer to the nearest Korg Authorized Service Cen-
ter for replacement.
Noisy audio Cables may be too long, or get interference from other devices on the stage. Use the
XLR connectors instead.
If the AMP MODEL is turned on, you might be listening to the natural noise of the
amp's valve circuitry.
P
ROBLEMS AND SOLUTIONS
Page
15
9
12
14
22
9
16
9
16
10